Took out Heather's Ninja 250 for a rip before she gets ready to sell it, she used the bike to commute during her time at college. Hope you guys enjoy the con I just bought a 2003 ninja 250, and I'm rebuilding the carbs because one is leaking from the overflow, and it's been sitting for a while, and float is stuck or trash in the needle seat. I noticed in the picture above a clear hose running out of the center of the carb, and noticed after pulling mine, that It didn't have this hose. Bike: 2003 Ninja 250 Bike hadn't been started in months. It starts up fine, but would die getting into gear or throttling up, so I decided to clean the carbs and change the gas. I took everything apart, cleaned her up, and put it all back together, following several guides and videos, as I had never done it before. You should drain them any time you think your next ride might be several weeks in the future. Getting the gas out of the float bowls helps reduce or eliminate the possibility of your carb internals getting gummed up and needing to be cleaned. It's the first step if you're going to be removing the carbs for cleaning. As part of troubleshooting a 4. Make adjustments 1/2 a turn in either direction to find the smoothest idle speed. Turn the screw counterclockwise and clockwise 1/2 a turn from the middle position and listen to the sound of the idle. Set the screw in the position where the engine’s idle sounds most even and smooth to balance the fuel mixture. Part Finder. Kawasaki. 2009. EX250 (NINJA 250R) Carburetor Parts. Search for Part. Our online part finder allows you to find the exact spare part you need and to order it online. All parts are genuine and supplied by either Kawasaki Australia, KTM Australia or Honda Australia. Any questions please call us on 02 4324 8916. .

ninja 250 carburetor problems